Danby DAC150EB1GDB Owner's Use And Care Manual page 11

USING THE REMOTE
CONTROLLER
BUTTONS
OPERATING INSTRUCTIONS
To set the Auto-start time.
1. Push the TIMER button when the unit is
off, only the Auto-start feature can be set.
2. Keep pressing the TIMER button, each
press will increase the selected time by
1 hour increments, up to 24 hours.
3. The time can be set in a range of 0~24
hours.
4. After the desired time has established,
wait for about 10 seconds until the
setting temperature reverts back in the
display window of the air conditioner.
This indicates the program is set.
NOTE:
To cancel the TIMER setting, push the TIMER button until 0 hour is
displayed on the LCD window of the air conditioner.
SLEEP OPERATION
• In this mode, the selected temperature will
increase (when in cooling mode) by 2°F one
half-hour after sleep mode has been selected.
• The temperature will then increase by another
2°F after an additional half-hour.
• This new temperature will be maintained for 6
hours before returning to the originally selected
temperature. This ends the Sleep mode and the
unit will continue to operate as originally prog-
1 rammed.
• The Sleep mode program can be cancelled at
any time during operation by pressing the Sleep
button again.
TIMER OPERATION
press the TIMER button can set the Auto-
start and Auto-stop time of the unit.
NOTE:
• To set Auto-start time, the unit must be in
the OFF position.
1
• To set Auto-stop time, the unit must be in
the ON postion.
To set the Auto-stop time.
1. Push the TIMER button when the unit is
operational, only the Auto-stop feature
can be set.
2. Keep pressing the TIMER button, each
press will increase the selected time by
1 hour increments, up to 24 hours.
3. The time can be set in a range of 0~24
hours.
4. After the desired time has established,
wait for about 10 seconds until the
setting temperature reverts back in the
display window of the air conditioner.
This indicates the program is set.
9