Garelick 75055 Mounting Instructions

MOUNTING INFORMATION
1. Check parts against parts list.
2. Read Instructions completely before mounting.
3. NOTE: This product uses locknuts for a secure assembly.
Locknuts thread on harder than conventional nuts and
require a screwdriver and wrench for attachment.
TOOLS REQUIRED
1. Screwdriver
2. Crescent wrench adjustable to 7/16"
3. Drill
MOUNTING GUIDELINES
For best utilization of your helmsman seat, it is recommended
that the seat be mounted:
a) As high as possible to enable a clear view over the
bow.
b) As close as possible to the wheel, leaving just enough
room to slide onto the seat from the side (see Fig. 1).
MOUNTING INSTRUCTIONS FOR MODEL 75055
1. Position seat on port or starboard bulkhead of boat so it
will conform to the Mounting Guidelines given above.
Mark a line on the bulkhead where the seat bottom is
positioned (see Fig. 1). Make certain that the line is:
a) no higher above the deck than the stanchion leg's
measured length;
b) parallel to the deck's surface;
c) located on a good, solid surface suitable for mounting.
NOTE: This line will be used to position U-brackets (A) in step 8.
2. Refer to Fig. 2 and position both support brackets (B) on
the bottom of the seat so that:
a) Support bracket is allowed to extend a minimum of 1"
from seat bottom (However, make certain that all screw
holes are located on the seat bottom.);
b) Brackets are spread apart from each other on seat
bottom for maximum support and stability;
c) Bracket's centerlines are parallel to each other. This will
allow proper hinging action.
NOTE: It is allowable to mount support brackets over the hinge
on the seat bottom for correct positioning.
FIG. 1
Write for
a Complete
Catalog
Mounting Instructions for
Model 75055 Side Mount Helmsman
Seat Hardware with H-leg; Model 75014
PO Box 8, 644 2nd Street
St. Paul Park, Minnesota 55071
Parts List Model 75055
Ref. Factory No.
Letter Part No. Req.
A 50.455 2
B 59.026 2
C 03.096 22
D 59.027 2
E 59.042 1
F 03.080 2
G 03.017 2
H 10.001 2
Model 75014 H-leg contains:
two units of both D and H
one unit of E
3. Mark the bracket's hole locations on the seat bottom and
drill all with a 1/8" bit.
4. Secure the brackets to the seat bottom by aligning the
holes and using screws (C).
5. Snap both socket castings (D) over grooved ends of H-leg
(E).
6. Position socket castings (D) with H-leg (E) attached on seat
bottom so they are centered on the seat's side and at least
2" from the edge. Make sure that the flat side of the
sockets face toward the mounted support brackets (see
Fig. 2). Mark both socket's mounting holes and drill them
with a 1/8" bit. Secure both castings in position with 8
screws (C).
FIG. 2 BOTTOM VIEW
On the Web: www.garelick.com
Form 12.119
Description
U-mounting bracket
Support bracket
#10 x 7/8" screw
Socket casting
75014 H-leg
1/4-20 x 1-1/2" bolt
1/4-20 locknut
1" White poly tip
(over)
Phone: 651-459-9795
E-mail: mail@garelick.com
8/00