Advertisement
14. Fasten roof on the inside with safety hooks. (Fig 1D)
15. Place "C" (access) door panels and lock in place.
16. For maximum protection it is suggested that the area between the bottom of the enclosure
and the concrete base be caulked with the exception the "C" panels.
BOTTOM OF THE "C" ACCESS DOOR PANELS.
17. Provide ground-fault interrupter device in electrical circuit according to applicable codes.
Install heater, if applicable, as per manufacturer's instructions and governing local and
national codes.
18. REMOVE MASKING FILM IMMEDIATELY AFTER INSTALLATION.
If these panels get wet when the film is still on, water will irreversibly stain the panels.
Summertime heat will bake the film on the panels.
1. Assembly parts included:
A. 2- "A" (end) Panels
B. 1- "C" (drain door) Panel
C. 1- "C" (solid access) Panel
D. 1- "D" (roof) Panel
4- Inside Aluminum Corner Anchoring Brackets
E.
(6 for 800TLU880M and 1000TLU880M)
F. 2- Lifting Shocks
G. 4- Anchor Bolts
(6 for 800TLU880M and 1000TLU880M)
H. 1 Package of Hexhead Screws
I. 1- Masonry Bit (1/2" x 4")
J. 1- Magnetic Chuck (5/16")
2. Tools needed:
A. Hammer
B. Drill
C. ¾" Wrench
D. Hammer Drill
Page 3
CONTENTS
www.safe-t-cover.com
DO NOT CAULK THE
1-800-245-6333
12/28/2020
Advertisement
