Proline ICECUBE2 Operating Instructions Manual page 4

OPERATION
1. Plug the appliance in the mains socket.
• The
indicator light will flash on and off alternatively.
2. Open the cover, remove the ice basket and pour water into tank.
• Keep water level below the MAX level.
3. Press to begin the ice making cycle.
• The
indicator light will illuminate.
4. Select the size of the ice cube by pressing
• If the room temperature is lower than 15 ° C, it is recommended to select small ice cube in order to
avoid ice sticking together.
5. The ice making cycle lasts approx. 6 to 13 minutes, depending on selection of ice cube size and room
temperature.
• The recommended room temperature for ice making is 10 ° C to 43 ° C.
6. While the appliance is working, check water level periodically.
• If water pump can' t inject water, the appliance will stop automatically and the
will illuminate.
• Press
to turn off the appliance, fill the tank with water up to the MAX level and press
again to turn on the appliance.
• Allow 3 minutes for the refrigerant inside the compressor to settle before restarting.
7. The appliance will automatically stop working when the ice basket is full.
• • • • WARNING: Direct sunlight or sunlight reflection may cause the infrared sensor to malfunction. I f the
appliance does not stop, even with the ice cubes obstructing the sensor, , , , move the
appliance out of the sunlight.
8. Change water in the water tank every 24 hours to ensure a reasonable hygiene level. If the appliance is
not in use, drain all the water and dry the tank.
CLEANING AND MAINTENANCE
Before cleaning, make sure the appliance is turned off and the plug is removed from the mains socket.
Remove the ice basket.
T urn the drain cap clockwise to drain out the water.
English
.
3
indicator light