Regular Cleaning - Electrolux ERG 16610 User Manual

74 electrolux
The thermostatic control interrupts the
operation of compressor at regular
intervals for more or less time - during this
cooling is interrupted - temperature of the
cooling compartment increases and
defrosting occurs. After defrosting the
thermostatic control restarts operation of
the system.
Melting water flows through defrost water
outlet into the evaporative tray maintained
on the top of compressor and evaporates
due to warmth of it.
Check and clean the outlet of
melting water coming during
defrosting regularly. If it is
clogged the melting water gathered can
cause earlier failure as it can go to the
insulating of the appliance.
Clean the melting water outlet with the
supplied pipe scraper that can be seen in
the figure. The pipe scraper has to be
stored in the outlet.
Occasionally check the defrost water
outlet not to be clogged up.
The most typical case of clogging up in
the defrost water outlet when you put
food wrapped in some paper into the
appliance and this paper contacts back
plate of cooling compartment and
freezes to it. If you remove the food right
GB
at this moment the paper will tear and it
can cause clogging up in the outlet by
getting into it. So you are asked to be
careful - because of the above - when
placing foods wrapped in paper into the
appliance.
In case of increased demand e.g.
during heatwaves, the refrigerator
temporarily happens to operate
constantly - during this the automatic
defrosting is ineffective.
Remaining small ice and frost stains on
back plate of the cooling compartment
after defrosting period is not abnormal.

Regular cleaning

It is recommended to wash the inside of
the refrigerator in 3-4 weeks time.
Household cleaner or soap must not be
used.
After you made it no-current wash the
appliance using lukewarm water and
wipe it.
Clean the magnet door rubber profile
with clean water.
After cleaning plug the appliance to the
mains socket.
Dust and dirt collected on the back of the
refrigerator, condenser is recommended
to be removed and clean the evaporative
tray on top of the compressor once or
twice a year.