Using The Learning Function - Cambridge Audio MI+ User Manual

CHAPTER 3

Using The Learning Function

When using the learning function, point your device's remote control at
the M1+'s learning eye as shown in the following illustration:
3 ~ 5 cm
Learning
eye
REMOTE
CONTROL
Figure 3-1 Using the Learning Eye
After you have lined up your remote control with the M1+ learning eye,
you can use the learning function. Follow these instructions:
Press the learning button for Press the learning button for
three seconds. three seconds.
You hear a beep and then you
see the setup mode enable
screen to the right.
Note: This screen prevents you from
accidentally modifying your M1+.
Press each number button
until it disappears.
7
CHAPTER 3
1 1 1 1
1 1 1 1