Reset; Skip; Stop; Resume - Waikato SYP User Manual

Reset

The reset button will cause the sample process to stop, clear the sample count, go back to
purge and will wait for the start button to be pressed again.

Skip

This allows the user to move past samples if required. Multiple samples can be skipped by
pressing the button multiple times in quick succession.
Note: The table will rotate at a higher speed if it must travel further to reach the new sample
position.

Stop

This will stop the sampling process and change the Auto Sampler into an idle state. The
needle block will move to the purge location regardless of where it currently is.
Note: While stopped, the Next Sample Time won't be updated.

Resume

This will move the Auto Sampler back into the sampling state. The needle block will move
back to the sample that it was stopped at.
Note: When resumed the Next Sample Time won't be updated.

Refresh

When pressed all sensor data and battery voltage will be updated immediately.

Graph

The graph shows the data from the current sample file, but only loads the data when the
page refreshes. To hide or show specific data, just click on the data set in the legend
(Figures 1 & 2).

Menu

Click this button to navigate to the menu page.
Use nifty infographic to explain this more easily??
P8