Configuration And Use; Status Page; How To Start - Waikato SYP User Manual

Configuration and use

Status page

\
Figure 1: Ready to start sampling (1). Figure 2, Waiting for a delayed start (Starting
at Sample 25)
This page shows information about the current status of the SYP fluid sampler and a history
of the samples taken. It also provides environmental information to assist in the setup. This
page also allows the user to start at a specific sample, reset, stop, resume, skip samples,
and refresh data.

How to start

Before starting the sampler, ensure the settings are set correctly on the Settings page. If
you want to start at a specific sample, enter the sample number in the Start Sample field
before pressing Start.
To start SYP, press the Start button. The device will enter the sampling state where it will
start sampling immediately or sit idle waiting for a start trigger depending on the setup (see
Settings).
Once the Auto Sampler has started, the available buttons will change and the machine state
will update when it begins to run. Once the start button is clicked the Auto Sampler will also
create a new Sample file, where all the sample data for that run will be stored.
P7