Am AP502 Instructions

AP502, AP502T Instructions
Underside
View
(Fig. 1)
Landing Gear
(B)
Left Upper Wing
Aileron
Fuselage
Wing Struts
Left Lower Wing
Aileron
Top
View
(Fig. 3)
(A)
(B)
Left Lower Wing
(B)
Center
Wing
(B)
Struts
Right Lower Wing
Top
View
Wing
Struts
(Fig. 2)
Left Lower Wing
1. Remove plane pieces from packaging. Turn fuselage upside
down to access underside.
NOTE: When turning plane during assembly take care to
(B)
set it gently on a soft surface. Soft material can be placed
under Fuselage to elevate body of plane and take weight off
of fragile protruding parts during assembly.
Landing Gear
2. Set pegs in Landing Gear struts ends into holes on Fuselage
underside (crossed lines should face toward plane front) and
secure using 8 small screws (A) (Fig. 1).
Lower Wings
3. Set Wing Struts into slots in top of Left and Right Lower Wings with
notches in Struts facing toward tapered rear edge of wing. (Loops on Struts
should face away from wing tips and Strut tops should tilt forward.) Secure
using 2 medium screws (B) set into holes in each wing underside (Fig. 2).
4. Matching slots on inner edge of Lower Wings to pegs on Fuselage, push
Wings inward until flush with Fuselage sides. Secure Wings with 2 medium
screws (B) set in holes on inner underside of each Wing (Fig. 1).
Upper Wings
5. One Upper Wing is connected to Center Wing. Matching pegs in
remaining Upper Wing to slots in Center Wing/Upper Wing, push together
to complete Upper Wing. Secure with 2 medium screws (B) set in holes in
Center Wing underside (Fig. 3).
(B)
(B)
Right Upper Wing
The Netherlands
AM NL
Ambachtsweg 37
NL-3899 AM
Zeewolde
Hardware provided:
8 small screws (A)
18 medium screws (B)
Required for assembly:
Small Phillips screwdriver
6. Turn plane right side up. Set slots
in underside of Upper Wing over
top ends of Struts. Secure with
medium screws (B) set into holes in
top of Upper Wing.
Lines
7. Untie and separate lines before
attachment. Hook lines from rear
Fuselage Struts to loop on each
lower rear Wing Strut.
Hook lines from forward Fuselage
Struts to loop on each lower
forward Wing Strut.
8. Hook lines from Lower Wings to
loops on each upper rear Wing
Strut.
9. Hook lines from Landing Gear to
each upper forward Wing Strut.
10. Hook lines from Lower Wing
Ailerons to loops on each Upper
Wing Aileron.
United States
AM USA
888 Garfield
P .O. Box 21710
Eugene, OR 97402