Amron AMCOM III 2830A-13 Programming Instructions
  1. Manuals
  2. Brands
  3. Amron Manuals
  4. Headsets
  5. AMCOM III 2830A-13
  6. Programming instructions

Amron AMCOM III 2830A-13 Programming Instructions

Base station & remote headset
Hide thumbs Also See for AMCOM III 2830A-13:
1
2
3

Advertisement

Table of Contents

BASE STATION & REMOTE HEADSET PROGRAMMING
28B Wireless System Programming
REV 2.0
© 2020 - Copyright Amron International, Inc. All Rights Reserved

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AMCOM III 2830A-13 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Amron AMCOM III 2830A-13

Summary of Contents for Amron AMCOM III 2830A-13

  • Page 1 BASE STATION & REMOTE HEADSET PROGRAMMING 28B Wireless System Programming REV 2.0 © 2020 - Copyright Amron International, Inc. All Rights Reserved...
  • Page 2 Follow the steps below to clear the base-station. All remote units should be “OFF” before starting this process. 1. Remove base-station from the Amron Communicator lid. Channel selection buttons “1” and “2” are located on the rear side of base-station.
  • Page 3 3. Turn Amron Communicator power “ON”. Located on the bottom right of the HUB, turn the base-station dial switch “ON” and adjust it to a middle volume range. The Green LED, located on the left side of base-station next to power jack, will turn on.

This manual is also suitable for:

28b

Table of Contents