Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Griesser SoloTel 2
Summary of Contents for Griesser SoloTel 2
-
Page 2: Table Of Contents
Safety instructions Safety instructions Contents Safety instructions ......3 The instructions must be observed in order to Safety instructions for radio operation . -
Page 3: Safety Instructions
Observe all safety instructions for radio operation. Scope of supply SoloTel 2 (battery included in the device), wall bracket, 2 wall plugs, 2 screws. Only use radio systems which are approved and can be operated without interference. -
Page 4: Mounting Of Wall Bracket
Mounting of wall bracket Explanation of functions On the back of the device Mounting of wall bracket • The wall bracket must be fi xed so that the drill holes do not touch any electrical cables. • Before installing the unit in the 5 Learn button P required position, check that the transmitter and receiver are... -
Page 5: Programming The Transmitter
Explanation of functions Explanation of functions Group control unit Note A group is understood to mean the control of several receivers Do not press the P button until the receivers are in at the same time. The selected group is controlled by a travel programming mode. -
Page 6: Programming Additional Transmitters
Explanation of functions Explanation of functions If more than 10 bidirectional receivers are being programmed in the Programming additional transmitters channel at the same time, the transmitter channel in programming mode switches to group mode. The group mode is indicated by fast Note fl... -
Page 7: Stopping Programming Mode (Bidirectional) In The Transmitter
Explanation of functions Explanation of functions Intermediate positions of the blinds Stopping programming mode (bidirectional) in the transmitter Roller shutter Awning Venetian Interior blinds shading Press the STOP button for at least 6 seconds until the status display lights orange. Approaching end positions of roller shutter / Pos▼... -
Page 8: Operation Of The Transmitter Using Combio Ja Pulse
Explanation of functions Explanation of functions The pulse time can be changed by the user. Keep the STOP and 2. Also press the STOP- button. The blind will stop. The status UP buttons on a programmed transmitter pressed for 6 seconds display lights briefl... -
Page 9: Battery Replacement
Repair The channel in the transmitter is also deleted. Fault Cause Remedy In unidirectional radio operation, the status display lights for 6 Drive does not run, 1. The receiver is 1. Reduce distance to seconds: fi rst green briefl y twice and then red. status display lights outside the sending the receiver... -
Page 10: Ec Declaration Of Conformity
EC Declaration of conformity Address Address EC Declaration of conformity We hereby declare that the following mentioned product/s meet/s the standards of the European Community. elero GmbH Please visit our website if ProLine 2 Antriebstechnik Product name: you require a contact outside Linsenhofer Straße 59-63 Germany. - Page 11 Contents 20 | EN © elero GmbH...
Need help?
Do you have a question about the SoloTel 2 and is the answer not in the manual?
Questions and answers