Cutting A Hole And Mounting Installation Plate - Toshiba MML-UP0071NHP-E Installation Manual

5
CUTTING A HOLE AND MOUNTING INSTALLATION
PLATE
Cutting a hole
(Rear piping)
100 60
(Bottom piping)
100 70
1. After determining the pipe hole position, drill the pipe
hole ( 65 mm) at a slight downward slant to the
Ø
outdoor side.
NOTE
• When drilling a wall that contains a metal lath, wire lath
or metal plate, be sure to use a pipe hole brim ring
sold separately.
Mounting the installation plate and
screw position
(Side piping)
45
: Pipe hole (Ø80 mm)
• In case of block, brick, concrete or similar type walls,
• Insert clip anchors for appropriate mounting screws.
• Secure four corners and lower parts of the installation
(Unit : mm)
Wall
Floor
– 12 –
CAUTION
When installing the installation plate with a mounting
screw, do not use the anchor bolt hole.
Otherwise the unit may fall down and result in personal
injury and property damage.
NO OK NO
GOOD GOOD
Ø5 mm hole
Clip anchor
(local parts)
CAUTION
Failure to fi rmly install the unit may result in personal
injury and property damage if the unit falls.
make 5 mm holes in the wall.
Ø
NOTE
plate with 6 mounting screws to install it.
Installation Manual
Anchor bolt
Projection
15 mm or less
Mounting screw
Ø4 mm x 25 r
12-EN