Know Your Unit; Patch Test - Rio faceLITE Manual

Due to the loss of collagen and elastic tissue
as we age, the skin becomes thinner and drier
and develops sags and wrinkles. Aging skin is
also much more susceptible to the development
of brown spots and pigmentation. Additionally
the skin's dermis can lose from 20 to 80% of its
thickness during the aging process.
faceLITE™ uses two proven wavelengths of
light; 633nm (red light) and 830nm (near infra-
red light). These wavelengths have been shown
Face mask
1
Controller
2
On/Off
3
Before carrying out your first treatment you must carry out a sensitivity test (patch test).
1. Place faceLITE over your inner arm.
2. If at any time your skin feels HOT or uncomfortable
STOP using the device immediately.
To charge faceLITE insert the USB-C end of charging cable into the controller. Insert the USB connector
into a USB power supply. The 3 LEDs on the control unit will start to flash to indicate charging. When fully
charged all three LEDs will be illuminated.
Note: Always recharge when the last LED starts to flash. faceLITE will not operate whilst charging.
INTRODUCTION
in clinical studies to stimulate collagen and
elastin production cells through a process called
photobiomodulation.
faceLITE has been designed to deliver light directly
to the skin, ensuring that the maximum amount of
light hits its cellular targets and is not wasted.

KNOW YOUR UNIT

LED indicator lights
4
USB-C socket
5
USB charging cable
6

PATCH TEST

3. After the treatment wait at least 6 hours. If the
CHARGING
6
Head strap
7
Carry bag
8
skin on your inner arm appears red and/or itchy
then faceLITE is unsuitable for you.