Widney JSG12ST-S25 Installer Manual

Widney JSG12ST-S25 Installer Manual

Instantaneous

Advertisement

Quick Links

1
GB
JSG12ST-S25
Instantaneous Gas Water Heater
Suitable for use in the following countries:
AT, CZ, FR, GR, IE, IT, LT,
PT, RO, SK, SI, ES, CH, GB
INSTALLER MANUAL
GAS SAFETY (INSTALLATION AND USE) REGULATIONS 1998 (AS AMENDED)
It is a Legal requirement that all gas appliances must be installed by a registered
person in accordance with the above regulations.
Failure to install appliances correctly could lead to prosecution. It is in your own
interest, and that of safety, to ensure that the Legal requirements are complied with.
Read these instructions carefully before attempting to operate the appliance. Comply
with all applicable warnings.
Do not interfere with any sealed components, and use the appliance only in
accordance with these instructions.
RECOMMENDATIONS - FOR THE INSTALLER
This appliance must not be installed, adjusted or adapted for use with another type of gas.
GAS SAFETY (INSTALLATION AND USE) REGULATIONS 1998 (as amended)
It is a Legal requirement that all gas appliances must be installed by a registered person in accordance with the above
regulations.
Failure to install appliances correctly may lead to prosecution.
It is in your own interest, and that of safety, to ensure that the legal requirements are complied with.
In addition to the above regulations, this appliance must be installed in accordance with the current IEE Wiring
regulations, Health and Safety Document No 635 'The Electricity at Work Regulations. It should also be in accordance
with the relevant recommendations in the current editions of all relevant National Standards. Your particular attention
is drawn to the following standards relevant to an installation in Leisure Accommodation Vehicles:
BS EN 1647:2018 Leisure accommodation vehicles; Caravan holiday homes; Habitation requirements relating to
health and safety.
BS EN 721:2019 Leisure accommodation vehicles: Safety ventilation requirements.
BS EN 1949:2011+A1:2013 Specification for the installation of LPG systems for habitation purposes in leisure
accommodation vehicles and in other vehicles.
BS 5440-1:2008 Flueing and ventilation for gas appliances of rated input not exceeding 70 kW net (1st, 2nd and 3rd
family gases). Specification for installation of gas appliances to chimneys and for maintenance of chimneys
BS 6891:2015+A1:2019. Specification for the installation and maintenance of low pressure gas installation pipework of
up to 35 mm (R1
) on premises.
1
4
Codes of Practice
CoP
501
CoP
502
IMPORTANT: References to the above standards are for guidance only. Installers must always check to ensure that
the references made to EN and BS standards in this document are to the latest requirements.
The installation must be according to national and local regulations and the requirements of the CPD (construction
products directive).
Manufacturer's instructions must NOT be taken in any way as over-riding statutory regulations
Always refer to technical information provided on the appliance data plate before installing this appliance
Ensure that the appliance is compatible with local regulations
GB
IE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JSG12ST-S25 and is the answer not in the manual?

Questions and answers

Summary of Contents for Widney JSG12ST-S25

  • Page 1 JSG12ST-S25 Instantaneous Gas Water Heater Suitable for use in the following countries: AT, CZ, FR, GR, IE, IT, LT, PT, RO, SK, SI, ES, CH, GB INSTALLER MANUAL GAS SAFETY (INSTALLATION AND USE) REGULATIONS 1998 (AS AMENDED) It is a Legal requirement that all gas appliances must be installed by a registered person in accordance with the above regulations.
  • Page 2: Water Heater Location

    INTRODUCTION The WIDNEY JSG12ST-S25 Is a wall hung, room sealed, fan assisted, microprocessor controlled fully modulating gas Water heater for providing domestic hot water. It is particularly suitable for Caravan Holiday Home and Park Home use. It is not suitable for road going vehicles.
  • Page 3 The following notes are for general guidance: The Widney JSG12ST-S25 is a room sealed appliance and needs no purpose provided combustion air ventilation. If the water heater is to be built into a small cupboard or compartment (i.e. at minimum clearances) and overheating can be foreseen (i.e.
  • Page 4: Appliance Dimensions

    APPLIANCE DIMENSIONS: MODEL JSG12ST-S25 (side 60-100 flue configuration) JSG12ST-S25 (rear 60-100 flue configuration) J(water in) K(gas in) L(water out) WEIGHT 13.6kg 13.6kg...
  • Page 5: Installation Procedure

    INSTALLATION PROCEDURE 9. UNPACKING The Water heater is supplied in a separate carton. Care should be taken when unpacking to ensure there is no damage to the product. Included in the Water heater carton are: Installation and User instructions, Gas isolation valve & 100mm of 15mm dia Copper tube + flue clamping collar and sealing ring.
  • Page 6: Flue Installation

    12. FLUE INSTALLATION Positioning: The water heater MUST be installed so that the terminal is exposed to the external air. • • It is important that the position of the terminal allows free passage of air across it at all times. •...
  • Page 7 Connecting the flue system: Refer to diagram to assist in assembly. 1. Slide the inner flue pipe into the outer flue pipe ensuring that the spacer on the inner flue pipe is evenly positioned - Note for flue lengths less than 300 mm the spacer is not required, see diagram Eii.
  • Page 8: Installation Completion

    INSTALLATION COMPLETION 13. WIRING Observe all the usual precautions to ensure that the electricity supply is isolated before beginning any installation work. The heater should be wired as described in section 5. Important: this appliance must be earthed. 14. GAS AND WATER CONNECTIONS Connect the gas and water connections to the appliance using the appropriate fittings.
  • Page 9: General Guidance Notes On Hot Water Delivery

    Setting the mode operation: When the heater is powered up but in standby condition; press the button in the lower part of the display repeatedly to scroll through 3 different Mode box displays 1 of modes: following: “Auto”, “Eco”, or manual “ “ (no “...
  • Page 10 COMMISSIONING ENGINEER AND END USER FAULT CODES Fault Problem Identified Action to take Code Switch off mains power supply – then restart by switching mains supply on and Input Water Temperature sensor pressing the on off button on the control panel – If problem persists contact Fault service Switch off mains power supply...
  • Page 11: Routine Servicing

    18. ROUTINE SERVICING To ensure continued safe and efficient operation of the appliance it is recommended that it is checked and serviced at regular intervals. The frequency of servicing will depend upon the particular installation conditions and usage but in general once a year should be regarded as a minimum, even if only occasional usage has occurred.
  • Page 12 USERS INSTRUCTIONS Upon completion of testing the system the installer should: • Give the instructions to the user and explain how the heater works. Demonstrate the operation of the heater. • • Explain the LOCKOUT and how to re-set. Stress the importance of an annual service by a registered engineer. •...
  • Page 13 Short Parts List Short Parts List Part Number / Description Part Number / Description Part Number / Description General Components JSGBCU JSGFA JSGT01 Thermostat Burner Control Unit Fan unit JSGTH JSGCV - Control valve JSGB-Burner Inlet and Outlet Thermistor JSGCDP JSGIG - Ignition generator JSGFP - Ignition + flame sensing Control display pcb...
  • Page 14: Specification

    Specification Wall Mounted side flue, room sealed, fan assisted Water Heater with Product Description electronic control for water temperature and safety operation JSG12ST-25 Model Name Specification Value Gas Category II2H3P Gas Type adjusted for G31 Propane @30/37mbar Gas Burner Pressure Internally Regulated to 19.0 mbar (high) and 3.0 mbar (low) Efficiency 78.3%...
  • Page 15: Warranty And Service

    International Limited Warranty will become the property of Widney. Widney offers a limited warranty to all products. Any product first sold to end user is guaranteed to be free from defects in both components and workmanship under regular uses defined in user manuals during the warranty period.
  • Page 16 Widney Leisure Ltd. St Mary’s Road, Nuneaton, Warwickshire, CV11 5AU Telephone: 02476 377550 | Fax: 02476 388378 Email: sales@widney-leisure.co.uk | Web: www.widney-leisure.co.uk W00770 – Issue A...

Table of Contents