Call Settings; Diverts - SENDO SV663 Manual

Table of Contents

Advertisement

14
When using the alarm, please observe the
following notes:
Note
When activated, the alarm will sound for
approximately 45 seconds before switching off (if you
do not press d,
If the alarm activates during a call, the phone will
beep and the display will flash to indicate that the
alarm is active. As described above, press d,
switch it off, or g,
minutes.
If the volume is set to silent mode, the alarm will
activate but there will be no sound. The phone will still
vibrate if the vibrate feature is on.
The alarm will sound even if the phone is switched off.
The phone will power on (if battery power is
available) but you will not be able to receive or make
calls. If the volume was set to silent mode before the
phone was switched off, the alarm will still sound as
silent mode is cancelled when the phone is switched
off. Once the alarm finishes, the phone will switch off
automatically.

Call settings

φ
Find it:
Select this menu to define your call settings.
The options are as follows:
Auto answer
This feature is only applicable when certain
hands-free accessories (for example, a
personal hands-free headset) are
connected to the phone. When you receive
an incoming call with this feature set to On,
the phone rings three times before
automatically accepting the call.
Any key answer
When this feature is set to On, you can
answer an incoming call by pressing any
key, except the End c key.
Call waiting
This menu allows you to set the call waiting
feature
On
or g, Snooze).
Off
Snooze
to stop the alarm for ten
Select A Settings
Call settings
or Off. For more information on
call waiting, please see the Answering a call
section on Page 15.
>
Note:
Call waiting is a network service.
You may have to subscribe to this service
and it may not be available when
roaming. Check with Vodafone for
details.
Show my number
This menu allows you to select whether you
Off
to
show your phone number or not, when you
call someone:
Select this
Network
On
Off
Auto redial
When auto redial is set to On, the phone
will automatically redial a number when the
call attempt fails. If the other user's phone
is busy, the phone will wait a few seconds
before each attempt, and then beep when
it succeeds.

Diverts

φ
Find it:
This network feature allows you to divert your
incoming calls to your voice mailbox or to
another number. The options are as follows:
>
Note:
Your network may not support all
of these features. Any unsupported
features will not be shown in the menu.
All calls
When activated, all of your incoming calls
will be diverted.
When busy
When activated, calls will be diverted if you
are already in a call.
[[[
]]]
56
To
Set the phone to the Network
default setting.
Show your phone number to your
correspondent when you call.
Hide your phone number from
your correspondent when you call.
Select A Settings Diverts

Advertisement

Table of Contents
loading

Table of Contents