Quectel FWT 3G/4G Quick Start Manual

ANT
TEL 2
LED Indication:
On = Power is On
Off = Power is Off
On = Line looped
Flashing = Incoming call
On = Call has be accepted
On = Battery is good
Off = Battery is low
Telecable
Power Cable
POWER
SWITCH
ON OFF
TEL 1 DC 5V
POWER SPECIFICATIONS:
Voltage
5VDC
Current
Max. draw 300mA
Standby 100mA
+5VDC
0V
TELEPHONE:
The line out terminals can still have standard
PSTN touch tone telephones connected into it.
Warning: Any calls made using this telephone
will incur usual cellphone calling rates, charged
to the SIM card in the WT1020.
SETUP
1. Insert your SIM card into the SIM hold behind the cover, on the back of the 4G FWT.
Please ensure the SIM card has:
A, been activated. This is done by putting the SIM card in a cellphone and going through the commands.
B, unlocked and password turned off. This is also done using a cellphone, through it's menu.
C, credit. Each call made from the Panel will incur usual cellphone calling rates.
Please note a Data only SIM card will not work.
If your having trouble activating the SIM card ask your Cellular provider to help.
2. Wire the white Telecable into the 'Line In' terminal of the alarm panel.
Then plug the other end into one of the RJ-11 sockets on the 4G FWT.
3. Plug power pack into DC input socket on 4G FWT and NZ 230V switched main outlet.
Then turn power On, from mains oulet and power switch on 4G FWT.
4. Power the alarm panel up, now it's time to program.
For programming instructions please follow the panels programming manual.
FWT 3G/4G
4G/3G/2G CELLULAR UNIT
You will need a Spark, Vodafone
or 2Degrees SIM card for installation.