Martin AW6S7246AX User Manual page 7

9. Put the plastic caps, that you find in
the user manual bag, in the holes.
We recommend that you
keep the packaging and the
transit bolts for any transport
of the appliance.
Information for installation
Positioning and levelling
Adjust the appliance correctly to prevent
vibration, noise and movement of the
appliance when it operates.
1. Install the appliance on a flat hard floor.
The appliance must be levelled and
stable. Make sure that the appliance does
not touch the wall or other units and there
is air circulation below the appliance.
2. Loosen or tighten the feet to adjust the
level. All feet must rest firmly on the floor.
WARNING! Do not put
cardboard, wood or equivalent
materials below the appliance
feet to adjust the level.
The inlet hose
CAUTION! Make sure there is
no damage to hoses and there
are no leaks from the
couplings. Do not use an
extension hose if the inlet hose
is too short. Contact the service
centre for a replacement inlet
hose.
1. Connect the water inlet hose to the
back of the appliance.
45º 45º
20º 20º
2. Position it toward left or right depending
on the positon of the water tap. Make sure
that the inlet hose is not in vertical
position.
3. If necessary, loosen the ring nut to set it
in the correct position.
4. Connect the water inlet hose to the cold
water tap with 3/4'' thread.
Water drainage
The drain hose should stay at a height of
no less than 60 cm and not more than 100
cm.
You can extend the drain hose
to maximum 400 cm. Contact
the authorised service centre
for the other drain hose and the
extension.
It is possible to connect the drain hose in
different ways:
1. Make a U shape with the drain hose
and put it around the plastic hose guide.
2. On the edge of a sink - Fasten the
guide to the water tap or to the wall.
7