Advertisement
STANDARD EQUIPMENT
Reflector Telescope Assembly
Altazimuth Yoke Mount
Variable Height - Hardwood Tripod
20mm and 4mm focal length - .965" diameter eyepieces.
3X Barlow Lens
5 x 24mm Finderscope w/ focus adjustment
Vertical Stabilizer Bar
Accessory Tray
Hardware Pack
Tripod leg: 3-2.25" bolts, 6 -0.687" washers and 3-wingnuts
Accessory tray: 3-0.5" bolts, 6 -0.687" washers and 3-wingnuts
Tripod Leg Lock Screws: 3 pc.
Stabilizer Bar: 1 Mounting Screw
TELESCOPE ASSEMBLY
1. Remove telescope from the carton and Identify all components. READ THROUGH ASSEMBLY
INSTRUCTION BEFORE YOU ASSEMBLE YOUR TELESCOPE
2. Set-Up Tripod
Select one tripod leg and extend the
included in the hardware pack, insert a
Tighten the
(6).
remaining two legs.
1. Attach Telescope and Finderscope
Locate the pre-assembled
Mount (12). Note: Before assembling tripod legs to Altazimuth Yoke Mount,
make sure the Accessory Tray Braces (8) face inward.
and washers from the hardware pack. Position the mount over the
as shown
Leg (6)
holes in the mount. Insert the bolts through the holes at the top of a
A washer should be positioned on both outer sides of the
Leg.
Attach a wing nut to the bolt, but do not tighten it all the way. Repeat on
the remaining two
the mount, securely tighten all wing nuts. Remove the
Mounting Screw (11)
at the base of the
Locate the
Finderscope (1)
front of the telescope (closet to the eyepiece) and place the
exposed screws. The
Replace the nuts, and securely tighten the
2. Attach Accessory Tray
Locate the
Accessory Tray (9).
connect the
wingnuts)
wingnuts. Wingnuts should be positioned beneath the accessory tray. Do not tighten wingnuts until all
Accessory Tray Braces
Your Bushnell
from your telescope, please refer to the additional information below.
Tripod Leg Middle Section (7).
Tripod Leg lock Screws
Telescope Main Tube (14)
and align the holes in the
(fig.1).
. Once you have attached all
Tripod Legs
from the hardware pack and insert it into the opening
Vertical Stabilizer Bar (4).
with pre-assembled mounting bracket. Remove the two nuts located near the
Finderscope Focus Adjustment (16)
Using the accessory tray bolts, wingnuts and washers (
to the
Accessory Tray
are attached as some adjustments may be required.
Telescope is now ready to be used. To obtain the fullest enjoyment
Tripod Leg Lock Screw
so that the
Middle Section
and
Altazimuth Yoke
Locate the long bolts
Tripod Leg
Tripod Legs
Stabilizer Bar
Finderscope
should point towards the
and bracket assembly in place.
Finderscope
Accessory Tray Braces (8)
Using the
Tripod Leg Lock Screws (10)
into the lower brackets on the
is securely in place. Repeat for the
Tripod
with the
Tripod
Tripod Leg.
to
and bracket assembly over the
. Start with one tripod leg and attach
Tripod Leg
fig. 1
Primary Mirror (13).
3-0.5" bolts, 6 -0.687" 3-
Advertisement
