Advertisement
Caution:
Transport and storage conditions:
Temperature: -4 ~ 140 °F
Humidity: 0 ~ 90% RH
Atmospheric Pressure: 500hPa to 1060xhPa
Use bits conforming to ISO standards
Suggested Maintenance
•Keep the handpiece clean of dust and grindings as best as possible.
•Wipe the handpiece down only with isopropyl alcohol gently and avoid getting
the inside components wet. It is normal for the handpiece to feel slightly warm
after continued usage.
•Do not oil the handpiece and do not clean with water (bearings are grease sealed).
•Clean gently with a can of compressed air.
Warranty
•1 Year on Control Box and 6 Months on Handpiece
(Warranty does not include misuse or normal wear of consumable parts)
Battery Warning
•Controller uses a Li-on Lithium Ion battery which can be recharged
approximately 500 times or has an approximate 5 years life.
Use the battery and enjoy the freedom and flexibility.
•In case of contact with liquids or body skin or eyes wash immediately.
•In case of shorter operating time between charging or if slower
speeds, it could indicate the battery is wearing or not charging
properly. Li-on batteries do not have a memory affect and do not
need complete discharge.
The battery is user replaceable.
1
Be careful not to drop
the handpiece as it may
damage the bearings.
2
If dropped, check if the
bit is bent or if any
excessive heat or nois
is generated, operating
it slowly and carefully.
3
Do not turn on the
power of the controller
while the collet of the
handpiece is in the
unlocked open position.
4
Always keep a bur or
blank mandrel in the
handpiece.
4
5
Do not put
the handpiece
down before
it stops rotating
completely.
6
Use safe
rotating speeds
suggested by
the bur
manufacturer.
Keep the
7
workplace
clean. Debris
may cause an
accident.
Always wear
proper eye
protection.
Advertisement
