Safety Instructions; General Commissioning; System Settings - SCHEU MINISTAR S Operation Manual

G
English

1. Safety Instructions

Carefully read the instruction manual and these important notes before commissioning and connecting the device, ensuring all requirements are met.
General notes
• Inspect the machine for damage before commissioning. If any damage is found, it shall not be operated.
• Always supervise the machine when it is switched on.
• Only use blanks of a diameter of 125 mm!
• Keep the device out of the reach of children!
• In order to protect the device against electric shock, any contact with liquids has to be avoided.
• Infrared heater and heater arm reach high temperatures during operation.
• Avoid flammable material coming close to the infrared heater.
• Only touch the handles to avoid any risk of burns.
• Transport of the machine shall effected solely if the machine is cooled down.
• Make sure the heater stays free accessible during transport to avoid any damaging.
• Safe operation of the device can only be ensured if original SCHEU-DENTAL spare parts are used. Servicing shall always be performed by qualified
SCHEU-DENTAL service technicians or at the SCHEU-DENTAL premises. Any conversion or modification to the device might impair product safety
and lead to loss of warranty claims.
• Never open the device without authorisation. Caution: Risk of injury!
• Never carry out repairs on your own!
• The device is designed for power supplies with an alternating voltage of 100 V, 115 V or 230 V. (Please observe the serial number label on the rear
of the device).
Installation of power supply on site
The installation of the power supply for connection of our devices shall take place in accordance with international provisions and the regulations
derived thereof.
Our devices are constructed according to VDE protection class I and shall be connected to a socket with protective conductor contact.
Environment
The machine is fabricated from reusable or recyclable material. In accordance with the directive 2012/19 Waste Electrical and Electronic Equipment
legislation (WEEE), SCHEU-DENTAL accepts to take back the device under the condition of free return delivery. Alternatively, the machine can be sent
to a designated collection point for the recycling of waste electrical and electronic equipment.

2. General commissioning

Please make sure to understand and follow the below instructions to make optimal use of the MINISTAR S
in its working environment, make sure there is sufficient space for the infrared heater 1, the pressure chamber 2 and the locking shaft .The
MINISTAR S shall be placed in a clean environment which is free from dust and plaster. Do not place the machine near to to a steam cleaner or
®
sandblasting unit.
The enclosed stainless steel pellets should be filled into the model cup  and the remaining quantity into the pellet receiver 5; when using the
model platform 6 make sure its surface in the model cup is free from pellets. The contact faces on and under the model cup have to be free from
pellets as well.
When embedding the model, only use the stainless steel pellets provided with the machine. Other material (e.g. rice or sand) might lead to serious
damage of the pneumatic part and the air outlet. If lighter weight materials are used these may ingest into the air stream during pressurising and
evacuation. Connect the MINISTAR S
is free from oil residues and humidity and has a minimum feed pressure of 4.0 bar.

3. System settings

Customise the settings of language, pressure, temperature and screen contrast according to your individual needs.
Switching on the device
As soon as the firmware version appears on the screen, press at least 5 times – possibly even more times – the „CE" button, until you see „language
selection" on the display. If „material selection" is indicated on the screen, make sure to switch off the unit and to repeat the process.
Language selection
Select figure – confirm pressing button „code/scan" 
Pressure selection
Select figure – confirm pressing button „code/scan" 
Temperature selection
Select figure – confirm pressing button „code/scan" 
Contrast selection
Select figure – confirm pressing button „code/scan" 
® machine by plugging in only the original power and air connections; make sure the compressed air supply used
machine. When placing the MINISTAR S
® ®