Discharge Assembly
As detailed in the diagrams below, the unit can either be assembled with front or rear
discharge depending on installation position and preference.
FRONT DISCHARGE
1 . Pull metal plate up to the closed position
and latch . This will direct food to the
bottom of the toaster .
2 . Pick up the longer of the two chutes .
3 . Slide the flanged end of the chute up
underneath the toaster .
4 . Rest the flanged end of the chute onto
the interior ledge .
Before Using Your Toaster
Before cooking anything in your oven for the first time, please follow these simple
instructions:
1 .
This conveyor toaster has been designed to continuously produce toasted bread or buns .
The desired toasted color of the product can be adjusted by changing the belt speed of
the conveyor . Depending on installation position, the toasted product can be discharged
to the front or rear of the unit .
2 .
Ensure the support feet are assembled to the unit before commencing operation .
3 .
Thoroughly clean as described in the cleaning section of this manual (page 6) .
4 .
For best results, allow the unit to preheat for 20-25 minutes before use so that the correct
operating temperature can be reached .
User Manual
REAR DISCHARGE
1 . Push the metal plate down to the open
position . This will direct food to the back
of the toaster .
2 . Loosen the two rear screws .
3 . Pick up the smaller of the two chutes .
4 . Slide the two keyholes on the chute behind
the loosened screws . If the chute does not
fit all the way down, loosen the screws more .
5 . Tighten the screws to secure the chute
to the toaster .
- 5 -