Table of Contents
Advertisement
ADJUST GUARD
• DO NOT operate Cut Off Tool without Guard in place!
• Disconnect air supply from the tool to prevent accidental starting and potential injury while
making adjustments to the Guard (Fig 2).
• Using the included 3mm Hex Key, loosen the Socket
Head Clamping Screw slightly, rotate the Guard to
the desired position then re-tighten screw.
OPERATION
• Adjust the Speed Control Lever located on the left
side of the handgrip section of the main tool body
(Fig 3).
• Connect air supply, hold tool
securely, flip Safety Lever
under Paddle and depress
Paddle to begin rotating action
(Fig 3).
MAINTENANCE
• Add several drops of air tool oil
before each use directly into
the air inlet.
• If tool is to be unused for an
extended period, add 10 drops of air tool oil directly to the air inlet, rotate the tool motor by
hand several times to distribute the oil throughout the motor and gearbox then store the tool,
handle up.
• With the air supply disconnected, periodically check that the Socket Head Wheel Retaining
Screw is tight.
6
INJURY HAZARD!
INJURY HAZARD!
FIG. 3
Press Paddle
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
FIG. 2
Rotate To Adjust Speed
Rotate
Safety Lever
Advertisement
Table of Contents
