Setup And Connection - Eastwood 31921 Instructions Manual

SET-UP & CONNECTION
Be sure that the air supply to the tool is clean and dry. Moisture in the supply line
will quickly damage the air motor and valves. A minimum 3/8" I.D. air line should be
used for optimal performance.
• Thread the included 1/4" Male NPT quick disconnect fitting into the 1/4" NPT inlet threads
of the Cut-off tool.
• Attach Air Supply to Inlet Fitting.
INSTALL CUT-OFF WHEEL ( NOT INCLUDED )
• Disconnect air supply from the tool to prevent accidental starting and potential injury while
installing or removing Cut-off Wheels.
• To avoid injury, only use replacement Wheels rated for High-RPM, (20,000 or greater) use.
• The Cut-Off Wheels are removed and installed
by gripping the flats on the output shaft with the
included 14mm Flat Arbor Wrench while placing
the Included 5mm Hex Key Wrench into the
Socket Head Wheel Retaining Screw threaded
into the arbor shaft.
• Turn the screw in a counter-clockwise direction
when viewed from the end. Remove Retaining
Washer (note outward orientation of beveled
edge) then remove cutting wheel (Fig 1).
• Place replacement wheel over the stepped 3/8"
[9.5mm] diameter portion of the shaft, replace
Retaining Washer in the proper bevel-out position.
• Re-install the Socket Head Wheel Retaining Screw, then use the wrenches to tighten (Fig 1).
Be sure the Socket Head Wheel Retaining Screw is securely
tightened on the output shaft before operating tool.
To order parts and supplies: 800.343.9353 >> eastwood.com
INJURY HAZARD!
INJURY HAZARD!
FIG. 1
5