Advertisement
General Operating Instructions
1. Make sure that the Trigger is in the
off-position, then attach the Battery Pack.
2. Insert an appropriate impact-rated
accessory into the driver.
3. Set Direction Switch.
Forward: Push Switch in on right side
(arrow pointing forward) for clockwise rotation.
Reverse: Push Switch in on left
side (arrow pointing backward) for
counter-clockwise rotation.
Trigger Lock: Push Switch to the
center to lock the Trigger.
CAUTION! Set Direction Switch to center
Trigger Lock position during set up, when
changing bits or when tool is idle.
Push
for
Forward
Push to Center to
Push to Center to
LOCK TRIGGER
LOCK TRIGGER
Item 64755
Push
for
Reverse
For technical questions, please call 1-888-866-5797.
4. Install bit and select direction of rotation.
NOTICE: Do not change direction of rotation
while Chuck is rotating. Wait until Chuck has come
to a complete stop before changing direction.
5. Press Trigger to start the tool. The Work Lights
will turn on when Trigger is pressed and turn
off a few seconds after Trigger is released.
6. The tool has variable speed.
To increase speed, apply more pressure to Trigger.
To decrease speed, lessen pressure on Trigger.
7. Tighten or loosen the fastener(s) as required.
Note: The amount of actual torque will vary depending
on the cleanness and condition of the threads and
other factors. If tightening critical components,
chase threads before assembling components and
check the actual torque applied to the fastener
with a mechanical torque wrench (not supplied).
8. When finished using the Impact Driver, release
Trigger and center Direction Switch to lock Trigger.
9. To prevent accidents, turn off the tool and
remove its Battery Pack after use. Clean, then
store the tool indoors out of children's reach.
Page 9
Hide quick links:
Advertisement
