Table of Contents
Advertisement
Reversing the Door
This beverage cooler has the capability of the door opening from either the left or right side. The unit
is supplied with the door opening from the left side. Should you desire to reverse the opening direction,
please see the following reversal instructions.
Door open from left side
1. Remove the upper hinge cover (1).
2. Remove the three screws (2) that hold the upper door hinge (3). Remove the hinge.
3. Lift the door and place it to a padded surface to prevent scratching.
4. Remove the three screws (6) that hold the lower door hinge (5). Remove the hinge.
5. Remove the hole cover (7) and transfer it to the same location on the opposite side.
6. Insert the lower door hinge in the left side, fix the lower left hinge by tightening all the screws.
7. Remove the pin cap (9) from the left side of the upper frame of the door and transfer it to the
same location on the opposite side.
8. Place the door on the lower door hinge (5), keep the door level and fix the upper hinge (3) to the
appliance body (9) using the screws.
9. Install the upper hinge cover (1) on the upper hinge
Replacing the light
The product comes fitted with an energy efficient long-life LED light. The light switch is located
underneath the thermostat controller. If the light needs to be replaced this must be done by a qualified
engineer. Light spec is E14, 220-240V, 50Hz, 0.8W.
Figure 1
Figure 2
Door open from right side
7
Advertisement
Table of Contents
