Table of Contents
Advertisement
(fully recessed).
Place the appliance on a flat surface that is strong enough to support it when it is fully loaded.
To level the appliance, adjust the levelling legs at the bottom of the unit.
Allow 125mm of space between the back and sides of the unit which allows sufficient air
circulation to cool the compressor.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
Avoid locating the unit in moist areas.
Plug the appliance into an exclusive, properly installed, earthed wall outlet. Do not, under any
circumstances, cut or remove the third (earth) prong from the power cable. Any questions
concerning power and/or earthing should be directed to a certified electrician.
After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing items in the compartment.
Electrical Connection
Improper use of the earthed plug can result in the risk of electrical shock. If the power cable is
damaged, it must be replaced by a qualified electrician.
This unit should be properly earthed for safety reasons. To minimize the possibility of electrical shock,
the power cable of this unit is equipped with a three-prong plug which fits a standard three prong wall
outlet.
This unit requires a standard 220~240V AC ~/50Hz electrical outlet with three-prong earth. Have the
wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly earthed.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly earthed 3-prong wall outlet. Under no circumstances should this
appliance be connected to a 2-prong outlet.
To prevent accidental injury, the cable should be secured behind the unit and not left exposed or
dangling.
The unit should always be plugged into its own individual electrical outlet which has a voltage rating
that matches the rating label on the appliance. This ensures the best performance and prevents
overloading of domestic circuits that could cause a fire hazard. Never unplug the unit by pulling the
power cable. Always grip the plug firmly and pull straight out from the receptacle. Repair or replace
immediately all power cables that have become frayed or otherwise damaged. Do not use a cable that
shows cracks or abrasion damage along its length or at either end. When moving the unit, be careful
not to damage the power cable.
Extension Cable
Because of potential safety hazards under certain conditions, it is strongly recommended that you do
not use an extension cable with this unit. However, if you must use an extension cable, it is absolutely
necessary that it be a 3-wire earthed type appliance extension cable with an earthed plug and outlet
and that the electrical rating of the cable is 220~240V / 13A.
Warning
6
Advertisement
Table of Contents
