Cleaning The Shower Head Faceplate; Replacing The Filters; Replacing The Solenoid Valve Cartridge - Franke AQCT0064 Installation And Operating Instructions Manual

21. Cleaning the shower head faceplate

21.1 Release the screw using an Allen key.
21.2 With a screwdriver, carefully lever out the spray faceplate.
21.3 Clean the shower head faceplate.
21.4 Reassemble in reverse order.

22. Replacing the filters

Water volume regulator filters
22.1 Remove the shower panel(see
22.2 Unscrew the locking screws (a) on the water volume regulators.
22.3 Replace the filters (b).
☞
Important!
Note the installation position of the filters.
22.4 Reassemble in reverse order.
Solenoid valve cartridge filter
22.5 Remove the solenoid valve cartridge (see
22.6 Use flat-nosed pliers to remove the filter (c).
22.7 Replace the filter.
☞
Important!
Note the installation position. The crosspiece of the filter may not be on top of the
flow hole.
22.8 Reassemble in reverse order.

23. Replacing the solenoid valve cartridge

23.1 Remove the shower panel (see
23.2 Disconnect the cable connection between the solenoid valve cartridge and the
AQUACONTACT sensor.
23.3 Loosen the screws (a).
23.4 Remove and replace the solenoid valve cartridge (b).
☞
Important!
The solenoid valve must be connected before the power supply is connected.
23.5 Reassemble in reverse order.
Chapter 20.).
Chapter
Chapter 20.).
- 14 -
23.).