Advertisement
MATE MT6AU USE AND
MAINTENANCE INSTRUCTIONS
ULTRA
XT AND ORIGINAL STYLE WITH 90° AND 315° OD SLOT PUNCH GUIDES ACHIEVED ANGLE SETTINGS FOR NON iRAM MACHINES:
TM
Use chart and illustration of "Single D" shape to properly orient punches and dies to each other.
EXAMPLE: Single "D": To achieve 0°, the punch must be ordered with shape setting of 270° and the die must be ordered with shape set at 180°.
Then place punch key in PA slot and die pin in DB slot as shown below.
Mate Precision Technologies • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone +1.763.421.0230 • 800.328.4492 • Fax +1.763.421.0285 • 800.541.0285
The Mate Logo is a registered trademark of Mate Precision Technologies Inc.
Dimensions in Inches(millimeters)
mate.com
© Mate Precison Technologies Inc.
LIT01374 Rev B
Advertisement
