Advertisement
ULTRA TEC
STANDARD ONE OD SLOT PUNCH GUIDE ACHIEVED ANGLE SETTINGS FOR NON iRAM MACHINES:
®
Use chart and illustration of "Single D" shape to properly orient punches and dies to each other.
EXAMPLE: Single "D": To achieve 0°, the punch and die must be ordered with shape set to 180°. Then place punch key in PB slot and die pin in DB
slot as shown below.
Mate Precision Technologies • 1295 Lund Boulevard • Anoka, Minnesota 55303 USA • Phone +1.763.421.0230 • 800.328.4492 • Fax +1.763.421.0285 • 800.541.0285
The Mate Logo is a registered trademark of Mate Precision Technologies Inc.
© Mate Precison Technologies Inc.
MATE MT6AU USE AND
MAINTENANCE INSTRUCTIONS
Dimensions in Inches(millimeters)
LIT01374 Rev B
mate.com
Advertisement
