Advertisement
OPERATION
• Grip the lamp housing and rotate Magnetic Base
through 360° in the vertical and 180° horizontally
on the pivoting Base (FIG 2).
• Place the base or rear of housing against any ferrous
metal surface for magnetic attachment.
• Release Retractable Hook to hang from overhead
objects.
• Depress and release round Button located at front of
Housing once for Color-Correcting LED Illumination
and a 2nd time for the Flashlight (FIG 1).
• Depress Button once again to turn off.
CHARGING
• When the LED power indictor located at the front of the Housing flashes RED, the battery
requires charging.
- Flip up rubber seal and plug the Micro USB terminal of the included Adapter Cord into
the Micro USB port.
- Plug the opposite USB end into the USB port of the included Wall Charger or any suitable
USB port (FIG 3).
- Plug wall unit into properly grounded 120 VAC,
60 Hz. outlet
- Allow 4 hours for full charge.
- The indicator LED at the front of the Housing will
illuminate RED while charging then change to
GREEN indicating full charge (FIG 1).
- Close Charging Port Cover to maintain
IP-20 rating.
Batteries will slowly discharge without use and must be charged every
3 months even if the light has not been used.
Do Not charge batteries in temperatures below 40°F [4.4°C].
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: techelp@eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com
© Copyright 2018 Easthill Group, Inc.
If you have any questions about the use of this product, please contact
PDF version of this manual is available at eastwood.com
FIG. 2
FIG. 3
8/18
Instruction item #32407Q
360°
Rotation
180°
Rotation
Rev 2
Advertisement
