The EASTWOOD WORKLIGHT SYSTEM features a Power Unit with 3 interchangeable COB LED Light attachments and a convenient USB type compact charger. A quick change, turn and lock design allows switching of attachments in just seconds. The handgrip style base features a thumb control switch with a strong magnetic base and a retractable 360°...
• Thoroughly read and understand this manual before using. • Save for future reference. EYE INJURY HAZARD! • DO NOT allow the Eastwood Quick Change lights to project directly into eyes. Temporary blindness may occur. • Never operate or store Lamp in damp or wet conditions.
Page 4
5° Clockwise until it locks (FIG 1). • To remove accessory, tightly grip the Power Unit and the Lock Collar of the accessory, push in and turn 5° Counter-Clockwise to release bayonet pins. FIG. 1 Rotate Align and push Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com...
- Hold in hand as a standard flashlight. - Set flat base on horizontal surface. - Set against any position, flat ferrous metal surface for Magnetic attachment. - Pull hook from base for 360° hanging position. To order parts and supplies: 800.343.9353 >> eastwood.com...
Page 6
- The array of 4 LED’s at the rear of the Housing will all illuminate to indicate full charge. - Close the rubber Charging Port Cover. CHARGING WHILE IN USE The Lamp may be used while charging, however it will greatly extend the required charging time. Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com...
Page 7
NOTES To order parts and supplies: 800.343.9353 >> eastwood.com...
Page 8
If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: tech@eastwood.com PDF version of this manual is available at eastwood.com The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com...