Advertisement
4. operaTIoN
4.1.
disconnect equipment from power supply.
4.1.1.
Insert tab shooter into collet of stud welder and secure with collet lock
nut.
4.2.
Insert tabs into the magazine.
4.2.1.
Slide handle of tab shooter down and up so that a tab is sticking out
from the tab shooter.
4.2.2.
Adjust the ground pin such that the tip of the tab protrudes 4mm past
the end of the ground pin (fig.2.)
4.3.
loading the tab shooter
4.3.1.
Unhook the end cap on the handle, be aware of the spring inside the
handle. This keeps the tabs in-place inside the magazine.
4.4.
operating the tab shooter
4.4.1.
once the tab shooter is set up in the machine, slide the handle down
and then up. This action will make a tab protrude out of the bottom
of the device. The tab will be held firmly by the tab shooter until you
pull the machine away from the work.
eNvIroNMeNT proTecTIoN
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk business park, bury St edmunds, Suffolk. Ip32 7ar
01284 757500
© Jack Sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
Ground Pin
locking screw
Ground Pin
fig.2
www.sealey.co.uk
SR2000TS Issue 1 21/08/18
Collet lock nut
Tab Shooter
Advertisement
