Advertisement
4.2.
ASSEMBLY
4.2.1.
The Storage Shelter comes partially assembled with
side arms (fig1.A and fig1.B) pre-built.
4.2.2.
Arrange items fig1.A and fig1.B such that A is to your right and B
pointing away from you (fig2).
fig.2
4.2.3.
Connect the two vertical support tubes (fig1.E) to side
arm arrangements (fig1.A, fig1.B) using fixings fig1.F,
fig1.G and fig1.H as shown in fig3.
fig.3
4.2.4.
Connect end brace (fig1.D) to side frames (fig3.A, fig3.B).Connect all top bars (fig1.C) across the side frames. Leave last C bar
unconnected at this stage (see fig4.)
4.2.5.
Fix locking bars (fig4.J) to hinge point using supplied fixings. Slide locking collar (fig4.K) over open ended tubes and run down to hinge
point.
4.2.6.
Lay cover over frame work ensuring the correct outer surface is on the outside (fig5). Slide the sleeves inside the cover over the open
ends of the assembly (fig5). Pass the last top bar (fig4.C) through the sleeve on the cover and connect to main assembly.
4.2.7.
Fold the cover backwards over the frame and from the inside, wrap the internal velcro fasteners onto the framework.
4.2.8.
Mark off the location for the rawl bolt ground fixings and install if required.
© Jack Sealey Limited
fig.1
fig.4
Original Language Version
on your left with the shortest tubes of the arms is
fig.5
MCS02
Issue 1 19/02/18
Advertisement
