Advertisement
Table of Contents
RPi4 CASE, WITH HEATSINK KIT
IMPORTANT SAFETY INFORMATION
When using electronic components basic safety precautions should always be
followed.
WARNING: This is an electrostatic sensitive device, take precautions to
ground yourself during the assembly procedure.
KIT CONTENTS
(a) x8 M3x10 Taptite Screws
(b) x14 M2.5x5 Screws
(c) x4 12mm Stand-offs
(d) x3 8mm Stand-offs
(e) x1 Aluminium End Plate
(f) x1 HDMI Extender PCB
(g) x1 Aluminium Carrier Plate
ASSEMBLY
1. Take carrier plate (g) & attach stand-offs
(c&d) with screws (b).
Attach both heat block (j&l) to carrier plate
(g) with screws (n) as shown.
Peel backing paper from adhesive pads
(k&m) & stick to each heat block (j&l).
Now remove remaining backing paper.
Assembly Instructions
MP004561 and MP004562
(h) x1 Aluminium Extrusion
(I) x1 Acrylic End Plate
(j) x1 Small Heat Block
(k) x1 Small Heat Pad
(l) x1 Large Heat Block
(m) x1 Large Heat Pad
(n) x2 M3x5 Screws
1
Advertisement
Table of Contents
Related Manuals for multicomp pro MP004561
Summary of Contents for multicomp pro MP004561
- Page 1 RPi4 CASE, WITH HEATSINK KIT Assembly Instructions MP004561 and MP004562 IMPORTANT SAFETY INFORMATION When using electronic components basic safety precautions should always be followed. WARNING: This is an electrostatic sensitive device, take precautions to ground yourself during the assembly procedure.
- Page 2 2. Plug extender board (f) into the HDMI & USB connectors on the Raspberry Pi board. 3. Place Raspberry Pi & extender on carrier plate assembly & secure with screws (b) as shown. 4. Turn board assembly over so carrier plate is on top &...
Need help?
Do you have a question about the MP004561 and is the answer not in the manual?
Questions and answers