Victor VLINK Startup Manual

START-UP GUIDE
LED
Set Bar
Indicator
Thumb Grips
Light
Easy-Set
Latch
Trap
Mounting Holes
Bait Tie
Kill-Bar
Down
QR Code
Label
Victor VLINK Mouse Trap Model: V420 | Victor VLINK Rat Trap Model: V430
® ® ® ®
®
1. Before you begin, confirm that you have a VLINK account
created and an Admin has added you to the account. Contact
your VLINK sales representative for confirmation if you are
unsure.
2. Confirm that you can successfully log-in at www.vlinkhq.com.
2. CONNECT THE GATEWAY
Rodent Grabbing
Teeth
Plug in the gateway.
If you are planning to use your local network, plug your
ethernet cable into the ethernet port.
Bait Cup
For all other gateway instructions, refer to the manual
provided with the unit.
1. Search for the Victor VLINK® app from the Apple App Store
or Google Play Store and download to your device.
2. Log-in using your VLINK® account credentials.
Kill-Bar/Antenna
3. Launch the app and follow the on-screen instructions to
connect your trap to the app.
Paste Baits
1. Place paste baits in the bait cup container.
2. Place bait in cup firmly to prevent it
from being pulled out easily by the rodent.
3. Placing bait on the trigger petal may lead
to non-capture triggers.
Tied Baits
1. Tie desired bait to raised Victor® V.
2. Orient bait towards middle of trap pedal.
1. ACCOUNT SET-UP
3. DOWNLOAD THE APP
4. BAIT TRAPS
5. CONNECT TRAP TO THE NETWORK
1. Hold the back end of the trap, place
both thumbs on the thumb grips.
2. Pull bar back into the easy-set
latch until it clicks and locks.
3. Take notice of LED light sequences
on the back left corner of the trap.
NOTE: Setting the trap can only be successfully accomplished
if the trap is level. If it is tilted significantly, it will not set.
LED Light Sequences
1. Green Flash When Set: The trap Is
set and fully powered on.
2. Yellow Flash: The trap is disengaged
and in power saving mode.
3. Red Flash When Set: The trap is set
but the battery is low.
4. Blue Flash: The trap successfully
communicated with the network.
6. PLACE TRAP
Once your trap is connected, place it in the area of rodent
activity and wait for the trap to alert you of a capture.
7. RESET TRAP AFTER A KILL
1. If a rodent has been captured, record your kill data using the
VLINK Mobile App.
2. Once the rodent is removed, the trap is ready to be baited
and reset for another capture.
3. To reset, simply pull the kill bar back to the set position
and wait for the green and blue LED flashes to let you know
the trap is communicating and ready for another kill.
Pro Tip: Avoid using strong cleaning products on the traps.
A captured rodent can leave behind scent and odor that can
make the trap more attractive to other rodents.