Related Manuals for Altman WORK LIGHT II
Summary of Contents for Altman WORK LIGHT II
- Page 1 WORK LIGHT II LED WORKLIGHT LUMINAIRE USER MANUAL WORKLIGHTII_USERS_MANUAL_20210702...
- Page 2 Vorschlaege in Bezug auf Korrekturen und/oder Aktualisierungen in diesem Handbuch, moechten wir Sie bitten, Kontakt mit der naechsten Altman Lighting Niederlassung aufzunehmen. Should you have a suggestion or question regarding your Altman Lighting product, we would love to hear from you. You can reach us at: Altman Lighting 1400 East 66th Ave.
-
Page 3: Important Information
Work Light II Installation & Users Manual Important Information Product Safety Notices When using electrical equipment, basic safety precautions should always be followed including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS. Do not mount near gas or electric heaters. -
Page 4: Altman Lighting Product Warranty
Altman Lighting, Inc., a subsidiary of Altman Stage Lighting Company, Inc., herein referred to as Altman, warrants each new product (except for spare parts or products Altman does not manufacture) for a period of FIVE (5) years and ONE (1) day from date of shipment to correct by repair or replacement any part defect due to faulty material or workmanship. -
Page 5: Table Of Contents
Work Light II Installation & Users Manual Table Of Contents Important Information Altman Lighting Product Warranty Table Of Contents Installation And Setup Power Requirements Connecting Power Mains Dimming Mounting Adjusting Tilt Installing C-Clamp Installing Safety Cable Cleaning and Care Special Cleaning and Care Instructions... -
Page 6: Installation And Setup
Note: The Worklight should be connected to Constant Mains power when using the local dim functions. When connected to a remote dimmer the Local Dim should be set to full on. The Work Light II Luminaire must be connected to and properly grounded to an viable earth ground. -
Page 7: Mounting
Work Light II Installation & Users Manual Mounting The LED Work Light is simple to install and position where work lighting is needed. The unit is supplied with a C-Clamp, Diffuser Frame, and Safety Cable. When mounting the LED Work Light, you must follow all national and local codes for safe installation and use. -
Page 8: Installing C-Clamp
Work Light II Installation & Users Manual C-Clamp Installation The provided c-clamp should be installed as shown in Figure 2. Only use the hardware supplied with the c-clamp. C-Clamp Worklight II Yoke 1/2-inch (13mm) Mounting Hole 1/2-inch Flat Washer 1/2-inch Lock Washer... -
Page 9: Cleaning And Care
Altman Lighting technical support (support@altmanlighting.com) or your local Authorized Dealer. MPORTANT! The Altman Lighting LED Work Light is a solid state, convection cooled luminaire. As with any solid state luminaire it is important that these units not run in a continuous 24/7 operation but be allowed sufficient OFF time during their operation. -
Page 10: Troubleshooting
Troubleshooting Guide The chart below provides possible causes and remedies for various error messages and/or symptoms. If this chart is unable to address your issue, please contact your authorized dealer or Altman customer service for assistance. Any service and maintenance (including troubleshooting), other than described herein should be performed by an Authorized Altman Lighting Dealer or Service Center. -
Page 11: Specifications
Work Light II Installation & Users Manual Specifications Materials: Materials: Corrosion-resistant materials and hardware Housing: Housing: Lightweight aluminum construction Control: Control: Phase Cut or Triac Dimmer, or Constant power with on board local fader control. Light Engine: Light Engine: 90W LED Array - Available in 3000K or 5000K...
Need help?
Do you have a question about the WORK LIGHT II and is the answer not in the manual?
Questions and answers