Table of Contents
Advertisement
Quick Links
LED Work Light
PREFACE
About this Guide
The document provides basic information on installation instructions for a qualified, trained
installer. Please read all warnings, notices, and instructions in this guide before installing or
using this product. Retain this guide for future reference.
Have a question regarding this guide?
The material in this guide is for information purposes only and is subject to change without
notice. Altman Lighting assumes no responsibility for any errors or omissions which may
appear in this guide.
Should you find an error, have a suggestion or question regarding your Altman Lighting
product, we would love to hear from you.
You can reach us at:
Altman Lighting
57 Alexander Street
Yonkers, New York 10701
1.914.476.7987 (Main)
1.914.963.7304 (Fax)
www.altmanlighting.com
customerservice@altmanlighting.com
Note: Information contained in this document may not be duplicated in full or in part by any person without prior written approval of
Altman Lighting. Its sole purpose is to provide the user with conceptual information on the equipment mentioned. The use of this
document for all other purposes is specifically prohibited.
Our Commitment
Altman Lighting continually engages in research related to product improvement. New materials, production methods and design
refinements are introduced into existing products without notice as a routine expression of the philosophy. For this reason any current
Altman Lighting product may differ in some respect from its published description, but will always equal or exceed the original design
specifications unless otherwise noted.
IMPORTANT INFORMATION
Product Safety Notices
When using electrical equipment, basic safety precautions should always be followed including the following:
a. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
b. Do not use outdoors unless the product is specified to operate in outdoor environments.
c. Do not mount near gas or electric heaters.
d. Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by
e. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
f. Do not use this equipment for other than intended use.
g. Refer service to qualified personnel.
SAVE THIS GUIDE FOR FUTURE REFERENCE.
©2018 Altman Lighting. All rights reserved.
unauthorized personnel.
Document Number: 49-0410
Version as of: 26 October 2018
LED Work Light Installation Guide
I
G
NSTALLATION
UIDE
1
Advertisement
Table of Contents
Related Manuals for Altman WL-130
Summary of Contents for Altman WL-130
- Page 1 Note: Information contained in this document may not be duplicated in full or in part by any person without prior written approval of Altman Lighting. Its sole purpose is to provide the user with conceptual information on the equipment mentioned. The use of this document for all other purposes is specifically prohibited.
- Page 2 Altman Lighting, Inc., a subsidiary of Altman Stage Lighting Company, Inc., herein referred to as Altman, warrants each new product (except for spare parts or products Altman does not manufacture) for a period of TWO (2) years from date of shipment to correct by repair or replacement any part defect due to faulty material or workmanship.
-
Page 3: Connecting Power
LED Work Light NSTALLATION UIDE INSTALLATION AND SET UP Power Requirements WARNING! The LED Work Light should be connected to a constant circuit or a relay device. It should never be connected to a dimmer or circuit controlled by a dimmer. Read this section carefully on how to properly connect your fixture. WARNING! All LED Work Light are shipped prewired from the factory. - Page 4 WARNING! Under no circumstances should ammonia-based cleaners, acetone, or other harsh solvents be used on or near the LED Work Light. These types of cleaners or solvents can permanently damage the fixture. If you have any questions regarding the use or care of your LED Work Light, please contact Altman Lighting technical support or your local Authorized Dealer.
Need help?
Do you have a question about the WL-130 and is the answer not in the manual?
Questions and answers