Advertisement
Available languages
Available languages
inside is more intensive.
In case of too intensive browning
a high quantity of acrylamide arises.
Therefore, you should avoid intensi-
ve browning.
STOP
Interrruption of toasting
Should the bread get too dark, the
toasting can be interrupted at any
stage by pushing this button.
Preheating/Postheating facility
If this button is pressed immediately
after switching the appliance on,
already cold bread will get once
again warmed crustily and bread
which ist too lightly browned will be
browned once again.
Thawing
If the thawing button is pressed
immediately after switching the appli-
ance on, the toasting will automati-
cally be extended in order to toast
frozen bread.
Bread roll attachment
The toaster has an attachment for
rolls that can be attached, if desired.
Two bread rolls can be crisped up
from both sides when using a medi-
um setting. Moisten bread rolls which
are too dry before, so that they tum
out well.
The rolls may not be placed in the
area of the handles. Otherwise, a
temperature accumulation may
damage these.
Crumb tray
During toasting the crumbs which fall
down will be collected in the crumb
tray. For emptying pulling the crumb
tray out of the appliance.
Cleaning and maintenance
Before cleaning unplug the appliance
and let it cool down.
Remove any crumbs stuck to the
browning slots and grids and on the
heating elements with a brush. Do
not tilt the appliance because other-
wise the crumb tray would empty into
the inside of the appliance. Slide out
the tray, clean it and put it again in
the appliance.
Never immerse the toaster in water.
Only clean the exterior of the appli-
ance as well as the roll attachment
with a damp cloth and some dish-
washing liquid. Do not use caustic or
scouring cleansing agents.
For UK use only
1. This product is supplied with a 13 A
plug conforming to BS 1363 fitted
to the mains lead. If the plug is
unsuitable for your socket outlets
or needs to be replaced, please
note the following. If the plug is a
non-rewireable one, cut it from the
mains lead and immediately dispo-
se of it. Never insert it into a
socket outlet as there is a very
great risk of an electric shock.
2. The replacement of the plug at the
mains lead has to be done accor-
ding to the following instructions:
Warning - This appliance must
be earthed
Important: The wires in this mains
lead are coloured in accordance
with the following code:
green / yellow:
Earth
blue:
Neutral
brown:
Live
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals
in your plug, proceed as follows:
- the wire which is coloured green
and yellow must be connected to
the terminal which is marked with
the letter E or by ,the earth sym-
bol
, or coloured green or
green and yellow,
- the wire which is coloured blue
must be connected to the termi-
nal which is marked with the
letter N or coloured black,
- the wire which is coloured brown
must be connected to the termi-
nal which is marked with the
letter L or coloured red.
3. If a 13 A (BS 1363) plug is used it
must be fitted with a 13 A fuse
conforming to BS 1362 and be
ASTA approved. If any other type
of plug is used, the appliance must
be proctected by a 10 A fuse eit-
her in the plug or adapter or at the
distribution board. If in doubt -
consult a qualified electrician.
4. Never use the plug without closing
the fuse cover.
The appliance complies with
the European directives
2006/95/EC and 89/336/EEC.
At the end of its lifetime this
product must not be dispo-
sed of through the normal
domestic waste, but it
should be handed to an
assembly point for the recycling of
electrical and electronical appliances.
You can inquire about details at the
local administration.
Subject to technical changes.
5
Advertisement
