Brother BE-0901E Settings Manual page 4

B E
B E
Setting of Lock Stitch
coming out of the garment.
Lock stitch ON/OFF at sewing start point
beginning of the design.
Lock stitch ON/OFF at sewing end point
the design.
Lock stitch ON/OFF at sewing start point after thread trimming
Inserts a lock stitch at the beginning of sewing after a thread trim.
Setting of Speed Limit in a Small Pitch
on small stitches. Must set a stitch width limit and the sewing speed at which anything under that
stitch width will sew. There will be two settings stored in the machine depending on the flat/cap
position. You will need to set these up in each different mode.
Default setting is OFF.
Recommended setting is ON.
Display of Information
Feed timing
– Determines when the pantograph starts to move in relation to the position of the
needle. Based on material thickness.
Default setting is THIN.
Recommended setting is THIN.
Automatic input setting
handled.
Default setting is MANUAL.
Recommended setting is MANUAL.
Hoop Retract Point
– Used to position the hoop in another place beside the start point. Can be used at
the start/end of a design or during the middle of sewing.
Automatic hoop retract
Default setting is OFF.
Recommended setting is OFF.
- 1 0 1 , 9 1 6 ,
- 1 0 1 , 9 1 6 ,
For Technical Assistance Please Call Toll Free 1-877-4BROTHER
Machine Settings
– Lock stitches are very tiny stitches used to keep the thread from
Default setting is OFF.
Recommended setting is ON.
Default setting is OFF.
Recommended setting is ON.
Default setting is OFF.
Recommended setting is ON.
Flats: 0.8mm at 720spm.
Caps: 1.0mm at 620spm.
- Displays information about the machine and sewing data.
– used to automatically read designs sequentially and how they are
– Goes to the hoop retract point at the end of sewing
9 0 1 , 1 2 1 6
9 0 1 , 1 2 1 6
– Inserts a lock stitch at the
– Inserts a lock stitch at the end of
– Used to automatically slow down the machine
4
, 1 2 0 1 A C
, 1 2 0 1 A C
–
Revised 1/10/05