Advertisement
Sensors
TREICHL-ATM Electronic Auf der Bült 10 - 12
Tel. 02166 958545
Reference Color Registration
1-Color Version
Manual Reference Color Registration
Follow the instructions below to register the reference color
using the Reference Color Set Button:
1. Set the synchronous mode to INT.
2. Aim the sensor at the color target, and press the button to
memorize the reference color.
3. Set the desired inspection tolerance, inspection mode,
response mode, and off-delay timer.
Remote Reference Color Registration
External Signal
Follow the instructions below to register the reference color
using an external signal:
1. Set the synchronous mode to INT.
2. When the sensor is aimed at the color target, input signals to
the SET input as shown below to memorize a reference color.
Set Signal
20 ms
A pulse of 20ms or more should be provided to the
SET input.
The interval between the SET signal and the external syn-
chronous signal should be 20ms or more.
3. Set the desired inspection tolerance, inspection mode,
response mode, and off-delay timer.
Input Set Wire/External Input Wire
Reference color can also be registered using the set input
wire (SET) and the external input wire (EXT) as shown in the
instructions below.
1. Set the synchronous mode to EXT.
2. Set the desired inspection tolerance, inspection mode,
response mode, and off-delay timer.
3. Input signals are transmitted as shown below.
Set Signal
External Signal
A pulse of 20ms or more should be provided to the
SET input.
The interval between SET signal and external synchronous
signal should be 20ms or more.
Registration can be timed by the external synchronous
signal only.
1. Remote registration cannot be performed when the
sensor is set in the FAST mode.
Reference Color Memory
Since reference color memory is stored in EEPROM, no bat-
tery back-up is required.
Fax 02166 958547
20 ms
20 ms
eMail: atm@treichl.de internet: www.lichtschranke.de
SA1J : Full Color Recognition
3-Color Version
Manual Reference Color Registration
Follow the instructions below to register the reference color
using the Reference Color Set Button:
1. Set the synchronous mode to INT.
2. Set the reference color selector dial to A. Aim the sensor
at color target A, and then press the reference color set
button to memorize color A. Repeat this procedure to
memorize reference colors B and C.
3. Set the desired inspection tolerance, inspection mode,
response mode, and off-delay timer.
Remote Reference Color Registration
External Signal
Follow the instructions below to register the reference color
using an external signal.
1. Set the desired inspection tolerance, inspection mode,
response mode, and off-delay timer.
2. Input signals are transmitted as shown below.
20 ms or more
Set Signal
External Signal
2. The example above illustrates registering color
C using three pulses of an external signal.
SET Signal
One Pulse Two Pulses Three Pulses
Registration
A
Reference colors A, B, and C are registered when an external
synchronous signal is on (immediately after the set signal turns
on). The number of impulses determines the reference color.
A pulse of 20ms or more should be provided to the SET input.
The interval between the SET signal and the external syn-
chronous signal should be 20ms or more.
For an external synchronous signal, refer to External Synchro-
nous Mode (EXT) on page H-9. Registration can be timed by
the external synchronous signal only.
When remote registration is used, color inspection can be timed
by the external synchronous signal. Whether synchronous mode
is INT or EXT does not affect the time of color inspection.
3. Remote registration cannot be performed when
the sensor is set in the FAST mode.
Reference Color Memory
Since reference color memory is stored in EEPROM, no bat-
tery back-up is required.
D 41189 Mönchengladbach
20 ms or more
20 ms or more
B
C
Advertisement
