Operation - KNOVA KN BD-46B Manual

ASSEMBLY
MOUNTING BELT/DISC SANDER TO WORKBENCH
Hex
nut
Lock
washer
Bolt
If the belt/disc sander is to be used in a permanent location,
it is recommended you secure it to a workbench or other
stable surface. When mounting the belt/disc sander to a
workbench, holes should be drilled through the supporting
surface of the workbench.
• Mark holes on workbench where belt/disc sander is to be
mounted using holes in the base as a template for hole
pattern.
• Drill holes through workbench.
• Place belt/disc sander on workbench aligning holes in
the base with holes drilled in the workbench.
• Insert bolts (not included) and tighten securely with lock
washers and hex nuts (not included).

OPERATION

WARNING
Do not allow familiarity with tools to make
you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING
Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure to
do so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING
Do not use any attachments or
accessories not recommended by the manufacturer of
this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
Lock
washer
Hex
nut
Fig. 9
CLAMPING BELT/DISC SANDER TO WORKBENCH
If the belt/disc sander is to be used as a portable tool, it is
recommended you fasten it permanently to a mounting board
that can easily be clamped to a workbench or other stable
surface. The mounting board should be of sufficient size to
avoid tipping while belt/disc sander is in use. Any good grade
Bolt
plywood or chipboard with a 3/4 in. thickness is recommended.
• Mark holes on board where belt/disc sander is to be
mounted using holes in the base as a template for hole
pattern.
• Follow the last three steps in section Mounting Belt/Disc
Sander to Workbench.
If lag bolts are used, make sure they are long enough to go
through holes in belt/disc sander base and material the
belt/disc sander is being mounted to. If machine bolts are
used, make sure bolts are long enough to go through holes
in belt/disc sander, the material being mounted to, and the
lock washers and hex nuts.
APPLICATIONS
This product has been designed only for the purposes listed
below:
• Sanding and finishing plastic, wood, and wood composition
materials
• Bevel sanding
• Horizontal and vertical sanding
• Sanding curved pieces
WARNING
of the sanding disc could cause the workpiece to
kickback and/or loss of control. Failure to heed this
warning could result in serious personal injury.
7
Applying the workpiece to the right side
Mounting
board
Fig. 10
C-clamps