Install The Drum Unit Assembly; Load Paper In The Paper Tray; Print A Test Page; Step 1 - Brother HL-2030 Quick Setup Manual

Step 1

Install the Drum Unit
2
Assembly
Do NOT connect the interface cable.
You will be prompted to connect the
interface cable during the driver
installation.
1
Open the front cover of the printer.
2
Unpack the drum unit assembly.
3
Rock it from side to side several times to
distribute the toner evenly inside the
assembly.
4
Put the drum unit assembly into the printer.
5
Close the front cover of the printer.
Load Paper in the Paper
3
Tray
1
Pull the paper tray completely out of the
printer.
8
Setting Up Your Printer
2
While pressing the paper guide release lever,
slide the adjusters to fit the paper size.
Check that the guides are firmly in the slots.
Paper guide release lever
3
Fan the stack of paper well to avoid paper
jams and misfeeds.
4
Put paper in the paper tray.
Check that the paper is flat in the tray and
below the maximum paper mark.
Up to here.
5
Put the paper tray firmly back in the printer.
4

Print a Test Page

1
Make sure that the printer power switch is
off.
Connect the AC power cord to the printer.
2
Plug the AC power cord into an AC outlet.
Turn the power switch on.
3
After the printer has finished warming up,
the Ready LED stops blinking and stays
green.
4
Press the Go button. The printer prints a
test page.
Check that the test page has printed
correctly.
Unfold the Support flap.