Nintendo Wii Operation Manual page 10

-5' 39.
3 U )
53 c
'0
System Setup
I Mounting the Sensor BarAbove the Screen
2. For additional stability, you can add adhesive 1. Remove the protective film from the foam pads
backed foam tape from the supplied sheet.
on the bottom of the Sensor Bar.
3. Mount the Sensor Barto the top of thelV.
0 The front of the Sensor Bar should be
aligned close to the front of the'lV.
0 The center of the Sensor Bar should be
aligned with the center of the IV.
I Mounting the Sensor Bar Below the Screen
2. For additional stability, you can add adhesive 1. Remove the protective film from the foam pads
backed foam tape from the supplied sheet
on the bottom of the Sensor Bar.
0 The front of the Sensor Bar should be
aligned with the front of the surface
the 'IV is sitting on.
3. Mount the Sensor Bar to the front edge of the
surface the1V is sitting on. Do not place the
Sensor Bar below the surface that then! is
sitting on; for example. on shelves below
the W.
0 lhe center of the Slensor Bar should be
aligned with the center of thelll.
S y s t e m S e t u p