Trouble Shooting - Pioneer BDP-09FD Service Manual

1

5.2 TROUBLE SHOOTING

A
Power ON Power ON Power ON
"NO DISC" is
displayed on
the FL display.
YES
B
Playback of a
Blu-ray disc
YES
Video
output from
each
connector
C
YES
Audio output
from each
analog audio
connector
YES
D
Perform an HDMI
connection with a
corresponding
amplifier. Play back
a CD and perform
PQLS operations.
E
OK
PureAudio
On/Off
operation
OK
F
Normal operation Normal operation Normal operation
32
1
2
• Check the power ON sequence.
• Check in the log that the model number of the drive has been recognized.
NO
Example: "PIONEER BD-** BDV-****, ATAPI CD/DVD-ROM drive"
If it is not recognized, check the power for the SPATA and ATA signals.
• Check that the ID No. and destination are set properly.
NO
• Check that the drive operates properly.
NO
• According to the descriptions on the video block, check the power to
the relevant IC and for the reset/clock signals.
• If an audio signal is not output from any of the analog audio connectors:
Check that power for each is supplied from AUPW to AUJB.
Also check the MCLK, BCK, and LRCK input signals between the MAIN and
NO AUJB Assys.
• If an audio signal is not output from a particular analog audio connector:
Check the ADATA0-3 input signals between the MAIN and AUJB Assys.
Check the digital input and analog output signals to/from the corresponding
DAC.
* Perform the settings on the unit as follows:
[Audio output]-[Output connector]: Analog audio
[Speakers]-[Audio output mode]: Multichannel
Check that "PQLS" is lit on
the FL display.
• Check that interlocked HDMI power On/Off functions properly.
NG
If it does not function, check the signal between Pin 19 of the HDMI (MAIN)
connector and Pin 23 of IC4001.
* Before the operation check, be sure to activate the KURO LINK function on
all connected equipment.
* Check that the LEDs, video
outputs, and audio power
relay can be turned on or
• If the LEDs and video outputs cannot be turned on and off:
off.
Check that the KEY0 signal between the MAIN and FLKY Assys responds to
NG
pressing of the PureAudio key.
• If the audio power cannot be turned on and off: Check switching of the 12-V
power supply and RY_ON signal between the MAIN and ACSW Assys.
*Perform the setting on the unit as follows:
[Audio output]-[Output connector]: HDMI MAIN
BDP-09FD
2
3
3
4
4