Advertisement
Available languages
Available languages
Hygrostat for pre-set humidity level
The MJS-900 is supplied with a built-in hygrostat that acts as an automatic humidity sensor, thus making it easier to maintain
just the right relative humidity. When the pre-set or programmed relative humidity has been reached, the humidifier
process pauses automatically. The humidifier process re-starts if relative humidity falls below the pre-set level.
Programmed humidity setting
Cold
In this mode, the humidifier maintains relative humidity at 55% to 70%. This makes breathing easier and relieves the
symptoms of colds.
Atopy
The MJS-900 can also help people who suffer from atopy* by maintaining relative humidity at between 50% and 62%
(adjuatable in increments of 2%). This level of humidity is also suitable for babies.
*An inherited tendency to certain allergic reactions, such as pollen allergy and asthma.
Adjustable misting level
You can adjust your humidifier's misting level by selecting low,
15
medium
or high
Sleep
In Sleep or night-time mode, the humidifier cuts back, and relative humidity is set to 60%. The humidifier runs continuously
for 8 hours in warm mode (WARM) and then shuts off automatically
No Water
The MJS-900 is supplied with a built-in water level sensor that warns when the water level is too low. Five audible signals
sound and the "NO WATER" indicator flashes continuously as a status warning. This is to remind the user to add water to the
tank.
De-mineralising filter
When the water runs through the de-mineralising filter, it is transformed at ionic level and the dissolved mineral salts and
other additives are removed, leaving softened water. These accessories help reduce mineral deposits in the nebuliser and
enhance ultrasonic humidifying.
USING THE HUMIDIfIER
Check that the plug is not connected to the wall socket during installation, refilling with water,
maintenance or transportation.
Note:
Step 1: Remove the humidifier from the box. Check that there is nothing in the water tank and
water container.
Step 2: Remove the water tank from the base and add clean lukewarm or cold water from the tap.
NOTE: Do not use water hotter than 40ºC.
16
Advertisement
