Advertisement
Available languages
Available languages
Step 3: Place the lid firmly on the water tank and put the tank back on the base. It is normal to hear
a rippling sound when a full water tank is put on the base. This occurs when the water runs
from the water tank into the water container. Wait a while until the water container is full.
Step 4: Choose a stable surface for the humidifier to stand on. Connect the plug to the mains and
switch on the humidifier. There is an audible signal. Press the "POWER" button and the
humidifier will start in automatic mode. Further information can be found under
"fUNCTIONS". Press the "POWER" button again when you want to switch the humidifier off.
The humidifier may stop automatically in the following instances:
1. The programmed relative humidity has been reached.
2. Insufficient water.
3. Power outage.
Cleaning and maintenance
Recommended maintenance
We recommend cleaning and maintenance of the MJS-900 at least once a week.
Before you start:
- Do not use cleaning agents, solvents or abrasives to clean the humidifier.
- Do not use brushes or rags that would scrape or scratch the humidifier.
- Do not leave water in the tank for more than one week.
Cleaning the cover
The MJS-900 should be regularly maintained and cleaned. Use a damp cloth and dry the surface so
that it will not collect dust.
Cleaning the water tank
Remove deposits and flakes by filling the water tank and shaking it vigorously. Tip the water out and
dry the inside of the tank carefully with a soft cloth.
Cleaning the water container
Tip the water out of the water container (see photo). Do not allow any water to run into the fan vent.
Remove deposits and flakes from the water container with a damp cloth.
Cleaning the nebuliser
Clean the entire surface of the nebuliser using the supplied brush or a soft cloth
IMPORTANT
1. If the nebuliser is not cleaned regularly, the humidifier will become less efficient and could even
become damaged.
2. Do not clean the nebuliser with solvent or abrasives.
3. Do not scratch the surface of the nebuliser.
Storage
If you put the humidifier away in storage, you must first empty it completely of water and dry the
water tank and water container. Store in a cool, dry place.
17
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
The humidifier is not working
• The plug is not plugged in
• The humidifier is not switched on
• There is insufficient water in the tank (the
No Water indicator lights up)
No misting
• The desired humidity level has been
reached.
• There is insufficient water in the tank
(the No Water indicator lights up)
• Deposits have collected in the nebuliser
The mist has a bad odour
• The humidifier has been poorly maintained.
• The water is not clean
• Stale water
The No Water indicator is on even
• The water level sensor (float) has got stuck
though there is enough water.
WARNINGS AND RECOMMENDATIONS
Do not add any additives to the water
Do not use cleaning agents, solvents
tank unless as directed.
or abrasives to clean the humidifier.
Do not use the humidifier if the flex is
The humidifier should only be repaired
damaged.
by a competent service technician.
Non-expert repair can pose a danger
to the user.
REMEDY
• Connect the cable
• Press the "POWER" button.
• Add water to the tank.
• Turn up the desired humidity level or wait until
the ambient humidity level falls.
• Add water to the tank.
• Regular maintenance of the humidifier.
• Regular maintenance of the humidifier.
• Empty out all the water from the tank and the
base, clean with tap water and refill with clean
tap water.
• Carefully release the float.
Do not cover any apertures and do
not insert any foreign objects into the
apertures of the humidifier.
Always place the humidifier on a
stable, level surface.
18
Advertisement
