Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Technologic Systems TS-9500
Summary of Contents for Technologic Systems TS-9500
- Page 1 TS-9500 Manual...
- Page 2 16610 East Laser Drive, Suite 10 Fountain Hills, AZ 85268 480-837-5200 FAX 837-5300 info@embeddedx86.com http://www.embeddedx86.com/ This revision of the manual is dated October 22, 2003 All modifications from previous versions are listed in the appendix. Copyright © 1998-2003 by Technologic Systems, Inc. All rights reserved.
-
Page 3: Limited Warranty
Limited Warranty Technologic Systems warrants this product to be free of defects in material and workmanship for a period of one year from date of purchase. During this warranty period Technologic Systems will repair or replace the defective unit in accordance with the following instructions: ... -
Page 4: Table Of Contents
Using LCD, Matrix Keypad with TS-9500 .................... 6 Booting from TS-9500 ........................... 7 Using the TS-9500 with a TS-3100 ......................7 Using the TS-9500 with a TS-2100, TS-2200, TS-2800 ................ 7 Jumper and Dip Switch Settings ......................8 Appendix A I/O Memory Map ........................9... -
Page 5: Introduction
PC/104 daughter boards, the user must ensure that there is no conflict with these I/O locations. Although the TS-9500 uses the full 16-bit bus, it can support SBC products with only an 8-bit bus (such as the TS-3100). All resources except the Compact Flash can function with a restricted 8-bit bus. -
Page 6: Compact Flash
BIOS, disabling both the LCD display and the console redirection to COM2, regardless of the state of jumper JP2. If a TS-9500 is present, all console input is disabled and the SBC will only accept input from a standard PC keyboard. -
Page 7: Booting From Ts-9500
Booting from TS-9500 The BIOS in the TS-9500 can be used to boot the attached SBC. Setting Dip Switch #1 "ON" will cause the BIOS in the TS-9500 to be executed instead of the BIOS firmware on the SBC. This can be useful if the main SBC flash chip has been corrupted. Setting the Dip Switch #1 to the “OFF”... -
Page 8: Jumper And Dip Switch Settings
See section Błąd! Nie można odnaleźć źródła odwołania. for more information. User Jumper Table 1: Jumper Settings Setting Shipping Switch Default Boot From TS-9500 ON = boot a 3000 series SBC OFF = boot a 5000 series SBC Reserved... -
Page 9: Appendix A I/O Memory Map
Appendix A I/O Memory Map Resource Address Board ID = 05Fh Bits 0 – 7 = Dip Switches 1- 8 Bit 0 = Led On/Off (1 = ON) Bit 1 = KB IRQ Bit 2 = Mouse IRQ ...