HP OneShred 8CC Operating Manual page 16

EN
Emptying the Waste Bin
Check the fill level of the waste bin through the viewing window at regular and when it is about
80% full, empty it. This prevents the shredded material from accumulating, which could lead to
malfunctions.
1 Slide the main switch to OFF.
2 Disconnect the power plug from the power socket.
Caution!
Risk of injury through sharp edge of cutting mechanism! The underside of the cutting
mechanism has sharp edges and corners. Only take hold of the cutting mechanism by the
grips.
3
Lift the shredder attachment from the waste bin.
4 Empty the waste bin.
Caution!
Risk of injury through sharp edge of cutting mechanism! The underside of the cutting
mechanism has sharp edges and corners. Only take hold of the cutting mechanism by the
grips.
5 Mount the shredder attachment on the waste bin.
Î The waste bin latches audibly in place.
Clearing Residual Material
If the shredder no longer shreds material as you expect, remove any residual material from the
cutting mechanism.
1 Slide the main switch to REV. The cutting mechanism runs in reverse and releases any materi-
al remaining in the cutting mechanism.
2 Slide the main switch to OFF.
3 Disconnect the power plug from the power socket.
4 Lift the shredder attachment from the waste bin.
Caution!
Risk of injury through sharp edge of cutting mechanism! Take the utmost care when
removing the material residue.
5 Remove the residual material carefully from the cutting mechanism using an appropriate
pointed object.
6 Mount the shredder attachment on the waste bin.
- 16 -