Page 1
Assembly Manual LED working light (7091.25)
Page 2
In the case in this assembly manual should only be of necessary repair work, please make undertaken by a Hako service centre or a workshop authorised by Hako. sure that only original spare parts are used.
Page 3
LED working light LED working light Parts list 1 1x LED working light compl. 2 1x flanged button head bolt M5x12 (Torx) 3 1x corrugated hose holder Before installation 1. Place the machine on a level surface and turn it off. 2.
Page 4
LED working light Installing the working light The working light is installed on the left next to the front wheel (Fig. 2/1). 1. Screw flanged button head bolt M5x12 (Torx) with working light into existing hole (Fig. 2/2). 2. Insert corrugated hose holder into existing hole (Fig.
Page 5
LED working light Configuration menu The LED working light option must be activated via the configuration menu. Value for LED working light: Option A. B. _. C. LED working light 1. 6. _. 1. A = Chapter B = Configuration C = Content 1.5.1 Button assignment Button 1 (Fig.
Page 6
LED working light 1.5.2 Setting in the Setting: 5. Press button 1 once. Configuration menu The dot to the right of the content 0 1. Open the configuration menu: flashes: Press buttons 1 and 2 simultaneous- Requirements: ly, switch on the key switch (Fig. 3/3) •...