Advertisement
Available languages
Available languages
Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present,
and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear
damage from shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product
must be returned to the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached room temperature.
1.
Power On/Off
2.
Fader channel 1 – 6
3.
Master fader
4.
Chase fader
5.
Speed fader
6.
Fade fader
7.
LED indicator battery
8.
OLED Display
9.
LED indicator Wireless DMX
10. Joystick
11.
DMX Output RJ45 Ethernet
12. DMX Output USB
13. Power input 5Volt / 1A
For a higher level of operational reliability, it is advisable to carry out your lighting installation wired. Use the XLR-RJ45 cable (included) or an XLR-
USB cable (not included) and connect the DMX line to the first DMX device. The DMX line is always transmitted as a serial data stream from one
connected to the following device via the "DMX IN" and "DMX OUT" connectors (XLR connectors) which can be found on every DMX device.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
Advertisement
